Sep 28, 2009, 14:58 GMT
Hamburg - The days when spray-paint graffiti artists could deface a historic facade will soon be over, thanks to a revolutionary new polymer coating developed by a team of German scientists.
And unlike conventional polymer coatings, this new coating permits the masonry to 'breathe,' lessening the risk of mould development or salt efflorescence.
It takes seconds to spray on graffiti, but hours or weeks to remove - especially from porous natural stone or brickwork as found in the majority of historic monuments. The paint penetrates deep into the pores from which it is impossible to remove, even with a pressure hose or multi-component solvents.
Often the only answer, other than living with the graffiti, is to etch away a part of the wall.
Special anti-graffiti polymer coatings have been on the market for several years. They create a hydrophobic seal that closes the pores, preventing the paint from adhering to the under-surface and allowing it to be wiped off.
But as a result, the building can no longer breathe, augmenting the risk of mould development or salt efflorescence. Because they cannot be removed easily, such coatings also run counter to the principles of conservation, which require that any changes must be reversible.
'There are conflicting requirements for this kind of polymer coating - it mustn't seal the pores, because it is important that there should be a continuous exchange of air between the building and the external environment, and at the same time it has to prevent the spray paint from penetrating the pores,' says Professor Andre Laschewsky, who heads the team of German researchers at the Fraunhofer Institute for Applied Polymer Research IAP in Potsdam, Germany.
'The coating needs to be sufficiently resistant to withstand both weathering and mechanical cleaning. Moreover, since we're dealing with historic landmarks, it must be possible to completely remove the coating from the walls if required, to restore them to their original condition with little effort and without damaging the structure,' he adds.
As part of an EU-sponsored project, Laschewsky's team and partners from the Centre of Polymer and Carbon Materials of the Polish Academy of Sciences in Gliwice and Zabrze have developed a polymer coating that meets these requirements.
'Our innovative polymer film seals the pores in the substrate, so that graffiti paint doesn't penetrate. But its micro-porous structure also creates a hydrophobic barrier that allows water vapour to escape from the building while at the same time preventing the infiltration of rainwater,' says Laschewsky.
The coating can be removed from the surface using a diluted brine solution which modifies its chemical composition and allows it to be washed off.
Coordinated by the LABEIN Foundation in Spain and the German Federal Institute for Materials Research and Testing, the partners have coated samples of ancient stone and brick and repeatedly covered them with graffiti - which was removed completely each time.
Your Talkback on this Story